DanWiggins's latest activity
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.TS on the input (amp/phone/DAP side)? Yes. it's mono. On the output (IEM/headphone side)? Nope. You only HAVE a mono signal to each...
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.Yes, any cable that has dual 2.5mm connectors will work with our IEMs. A lot of Sennheiser over-ear headphones use this connection, as...
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.Looks like it should work for you. Note that we're 100+ dB SPL @ 1 mW, so be careful with the volume! Also understand you'll have...
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.We're looking at that - but it won't be offered until the new year - we're focused right now on meeting demand for the new units.
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.Yeah, some recordings are a bit noisy, and you find those easily with decent IEMs!
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.They should be OK - we power-tested the design with 200 mW for 30 minutes... If you're not sure, we can test them for you if you send...
-
DanWiggins posted a reply to a review on the item Periodic Audio Beryllium (Be).Hmmm... Delivered less than day before your review. Not even going to give it a bit of time?
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.We're working hard on our connector, and a few other interesting things are in the works, too... Hoping to announce one of them at AXPONA!
-
DanWiggins replied to the thread The Hi-Fi + Hi-Res Audiophiles' Bluetooth Headphone Adapter Thread - [17.Oct.21] iFi GO Blu impression added.I back this 100%. RARELY is a DAC going to cause an audible issue unless the filter coefficients are really screwed up (which only...
-
DanWiggins replied to the thread Periodic Audio IEMs Mg, Ti, Be, C.Nice! I'll have to try that... When I need BT connectivity, I use an ES100 - but I run a Nickel off the ES100 to power my Be unit...