-
-
Benyboy replied to the thread Home-Made IEMs.I'm still new at this but I've tried glueing drivers in the Shell with uv resin which for now hold fine, I use a small syringe to place...
-
Benyboy replied to the thread Home-Made IEMs.After 3 months of learning reading and gathering information on diy iems I finally made a pair from scratch, I went with a hybrid build...
-
Benyboy replied to the thread Home-Made IEMs.I believe it's the 3800 series 38d1xj007mi that has a ferrofluid
-
Benyboy replied to the thread Home-Made IEMs.Hi everyone I have been following the forum for a while now and I've been learning at lot about designing iems, I started with...
-
Benyboy replied to the thread Home-Made IEMs.I was hoping to see a diagram of this set up I'm stuck with how to wire those drives, (+ - )/(+ +) (- -)? And if I wanted to keep the...
-
Benyboy replied to the thread Home-Made IEMs.How did you wire the 2389D, I got a fresh pair and not sure if middle tap is used on the dual ba or if it's series or parallel.
-
Benyboy replied to the thread Home-Made IEMs.Do you have a crossover and damper recommendation for this set up , I'm new at this with individual components, I did build a...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…