Denon 4300 and Triangle Elara, 5.0 setup, wires, Dolby and audio connectors
Dec 31, 2018 at 6:34 AM Thread Starter Post #1 of 2

metallon

New Head-Fier
Joined
Dec 30, 2018
Posts
2
Likes
0
Location
Berlin
Dear HiFi-Experts,

I have a DENON 4300H Amp, two Triangle LN07 front speakers and some older back ones left and right.
Just yesterday I got my Triangle LN02 center speaker and I have a few questions regarding my setup.

a) When I select Blue-Ray as input source I see HDMI in the top right corner on the amp.
When I select CD I read Audissey in the top right display corner of my amp.
Why is Blue-Ray not Audissey as well? Why would only CD as input is my Audissey-Mic measured room setup?

b) I have some thick cables that I got in the HiFi-Shop a few years ago and is it recommended I use
the same thickness for my new LN02 center now?

c) I notiched that the cable connectors that I used to wrap around the wire are really really hard to
get into the amp and the speakers. They even look out of the speakers at the back a bit.
Are they the right size or do I do something else wrong?

d) Would it make a difference if I select Dolby over DTS Neural X with my current setup (5.0)?

e) What would be the next logical speaker purchase to enhance the experience?
I dont need a subwoofer as the two big LN07 give plenty but what about a ceiling speaker or 7.0?

aud1.jpg


aud2.jpg

aud3.jpg
 

Users who are viewing this thread

Back
Top