[forge457]

got a question about the diff between the

tinhifi-t2-plus

Driver
unit: 10mm woofer Sensitivity: 104±3dB@1kHz 0.126VFrequency response: 10Hz-20kHzImpedance: 32ohm±15%Rated power: 3mWMax power: 5mWMax distortion: 1%@1kHz 0.126V

vs the CCZ **** Melody

https://hifigo.com/products/tinhifi-t2-plus-tin-audio-dynamic-driver-in-ear-earphone

Frequency response range: 20-20kHz

Sensitivity:110±3DB

Impedance: 16±2Ω

Cable material: OFC

Interface: 2PIN 0.78MM

i have both by the way

an does anyone know version of the **** Melody are these by the way?

id like to compare on

https://crinacle.com/graphs/iems/graphtool/?share=Harman_IE_2019_v2_Target

as for the tinhifi-t2-plus to me it sounds nice an flat the way i prefer but it seems to me also

about 6 - 8 db quieter the the **** is that really just because

of the spec diff

an as for adding on wireless option do you think the

Fiio UTWS3 Over Hook True Wireless Bluetooth Receiver are a good add

https://hifigo.com/products/fiio-ut...ess-bluetooth-receiver?variant=37756846604462

 

[GrBm]

Every time you halve the resistance (ohms) the amount of watts per volt double, double resistance watts per volt are halved. To get an increase of 3dB you need to double the watts/power.

The T2s are twice the resistance (ohms) and the sensitivity is 6dB less than the ones you are comparing them to. Adding up to a total on 9dB quieter than the others on the same power, assuming the sensitivity numbers given for each were using the same power (only the T4 specifies this). So yes, the T2s would be half as loud on the same power as the others (it takes ~+10dB for something to be perceived as twice as loud, 9dB is more than close enough).

 

[forge457]

Every time you halve the resistance (ohms) the amount of watts per volt double, double resistance watts per volt are halved. To get an increase of 3dB you need to double the watts/power.

The T2s are twice the resistance (ohms) and the sensitivity is 6dB less than the ones you are comparing them to. Adding up to a total on 9dB quieter than the others on the same power, assuming the sensitivity numbers given for each were using the same power (only the T4 specifies this). So yes, the T2s would be half as loud on the same power as the others (it takes ~+10dB for something to be perceived as twice as loud, 9dB is more than close enough).

thanks for that more detailed then i thought but i did think it might have something to do with it but just wanted to be sure thanks, they still go by the way solar fields sounds less muddy without any eq'ing