-
-
Ssunsun89 replied to the thread DIY Earbuds.hi just want to share my 3d design, my friend from earbud lovers indonesia request for 2pin termination for "hachi" shell heres the...
-
SWhen I tried the SS2590, I also thought they sounded better than any other OP-AMP I'd tested, and that's even though they're admittedly...
-
SUnfortunately there are always compromises to be made, aren't there? The XD05 PRO with SS3602s is still, to my ears, a...
-
SI was writing underpowered because the datasheet reports that the OP-AMP require at least +/- 9V...
-
SMy pci-e cards arrived the other day so I've finally had time for some initial testing with the SS2590s in XD05 PRO. Despite the clear...
-
Ssunsun89 replied to the thread DIY Earbuds.hi, just want to share personal project DIY, just for fun to test new driver. in this video I use 15.4mm 120 ohm berrylium, 1st...
-
SSomeone asked me to shoot this.
-
Ssunsun89 replied to the thread Earbuds Round-Up.Trying DIY earbud made by local builder at Indonesia. 3D printed shell inspired by Rose Tech. using 2 Driver, 1 piezo driver and 1...
-
Ssunsun89 replied to the thread DIY Earbuds.i start my 3D journey because of you @Mr.HiAudio :beerchug: thanks :beerchug:
-
Ssunsun89 replied to the thread DIY Earbuds.Yup, because the driver too small (14.2mm), if use straight down will easily get pulled down. but it doesn't come out of the ear, it...
-
Ssunsun89 replied to the thread DIY Earbuds.Make short video for new shell. in this video i make DIY earbud with 14.2mm driver.. the smallest earbud i ever build.
-
SHi All: First time posting on this forum. I finally had some time to sit and compare the Sparkos SS3602 and the Burson V7 Classic in...
-
Ssunsun89 replied to the thread DIY Earbuds.print another 3D shell, all of it has basstube/bassport to enhance sub bass region.
-
SIntroductions This is the Moondrop Blessing 3! It’s been a while since I’ve listened to one of these. I think this was one of the first...
-
Ssunsun89 replied to the thread DIY Earbuds.hi, just want to share my DIY earbud.. just for fun :) using 3D printed resin shell for 15.4mm driver. shell inspired by valsuki val39...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…