.........DAC Type stepped actuator instead of potentiometer? which one? this (10k of course)? how did it work compared to the ultra-cheap pot used inside the LD ?
a $20 stepped volume control ? How is the build quality?
.........DAC Type stepped actuator instead of potentiometer? which one? this (10k of course)? how did it work compared to the ultra-cheap pot used inside the LD ?
the sound is coming from the transformer, sound like a Magnetostriction effect to me. i have it will all kind of tubes i tested of various family. for the Wifi i tested close and far from any wifi source and i still have the sound. It is a second hand one that i bought on ebay so maybe the transformer just got a hit over the time.the transformer enclosure is made by iron and connected to ground via screws holding it to aluminium main housing and, from there, to the ground contact in the main power connector… so… are you sure is the transformer or maybe could be something related to the tube you are using or the Wi-Fi source not properly grounded and/or shielded?
Hi, Met you over on DIY Audio and have been enjoying this thread here on your rebuild! I have a couple questions, and you seem like the right guy to ask. first, why did you move the coupling cap, in input, in front of the pot? I know resisters and caps can sound different based on order, but what was your reasoning and what did you notice? Second question, what is the B+ voltage of this amp, stock? Does that appear at the 220uF output coupling caps? What do you think would be the lowest voltage rated caps safe to use there? Thanks in advance!! Enjoy your ides here! Been playing with mine and have some good results so far.All done.
I revised the negative feedback scheme with a set 220k resistor and switched in 330k and 100k, for paralleled resistance of 132k and 68.8k. With only the 220k resistor there is an attenuation of -3.4dB, with 132K, -5.4dB, and 68.8k, -9.2dB. I have nicely matched Voskhod 6J1P-EV and Novosibirsk 6N6P in the amp, and I had forgotten how nice it sounds.
One final change, I upped the film cap on the output to 4.7uF.
The ripple voltage to the 6N6P was 0.27mV and 3uV to the front section, so there's plenty of filtering in the power supply. No audible hum or noises.
The total resting power draw for the amp was only about 36mA. An interesting build can be done with a Hammond 269EX power transformer and a 6X4 rectifier tube with appropriate dropping resistors in the RC filtering circuit.