chaz_flhr
500+ Head-Fier
Has anyone purchased from high res audio I’m trying to decide between 44.1 FLAC or DSD64 the price difference is only 80 cents so I ca try out DSD?
I was asking because I read somewhere that the 4.4 version has a more powerful balanced output than the 2.5. But maybe I'm mistaken. I could get the 2.5 used for cheaper than the 4.4 so if they have the same power I will go that route.All great advice here, cheers! And correct on the 4.4mm note.
I was asking because I read somewhere that the 4.4 version has a more powerful balanced output than the 2.5. But maybe I'm mistaken. I could get the 2.5 used for cheaper than the 4.4 so if they have the same power I will go that route.
It's about that:Its a couple hundred mw difference if I remember correctly, nothing huge.
I was asking because I read somewhere that the 4.4 version has a more powerful balanced output than the 2.5. But maybe I'm mistaken. I could get the 2.5 used for cheaper than the 4.4 so if they have the same power I will go that route.
It's about that:
Pro iDSD 4.4mm socket. (16 Ω, balanced/single-ended): >4200mW /1>1,575mW
Pro iDSD 2.5mm socket. (16 Ω, balanced/single-ended): >4000mW /1>1,500mW
@tdx:
So, my bad. I have to correct myself. Besides, i would not have thought that there would actually be differences beside the connector dimensions. But it is negligible at all.
In my modest opinion, the 4.4 Version should be the way to go. Otherwise you could buy the 2.5 Version, if it is a good offer/ cheaper and use a 2,5 to XLR adapter and ignore the 2.5 plug.
Cheers
You are right, this is standard 2.5 pinout.@iFi audio please help!
I want to make DIY balance cable with 2.5mm TRRS male connector for Senn HD650 and iFi iDSD Pro.
Please confirm pinout:
Tip R-
Ring close to tip R+
Ring close to sleeve L+
sleeve L-
@iFi audio please help!
I want to make DIY balance cable with 2.5mm TRRS male connector for Senn HD650 and iFi iDSD Pro.
Please confirm pinout:
Tip R-
Ring close to tip R+
Ring close to sleeve L+
sleeve L-
You are right, this is standard 2.5 pinout.
When you're done: I would like a similar cable 3.5 mm from headphones (i.e. focal) to the 2.5 mm ifis too - where to get that if you're not an DIY person?@iFi audio please help!
I want to make DIY balance cable with 2.5mm TRRS male connector for Senn HD650 and iFi iDSD Pro.
Please confirm pinout:
Tip R-
Ring close to tip R+
Ring close to sleeve L+
sleeve L-
Amazon, Ali express or any of the custom headphone cable manufacturers I have Norneaudio cables and adapters.When you're done: I would like a similar cable 3.5 mm from headphones (i.e. focal) to the 2.5 mm ifis too - where to get that if you're not an DIY person?
Maybe I can be friends with him too@Sebastien Chiu @JaquesGelee Guys, thank you!
@TooFrank My friend is DIY master so he will do that cable for me